We have a high success rate with recovering data from. You can use Migration Assistant software (built into Mac OS X) to transfer all personal files, settings and applications to another Mac computer. In most cases of electronic failure your MacBook Pro, Mac Air and iMac hard drive will be completely dead. Now you can access and recover needed files. If the SSD is in good working condition your Mac should detect it. Select the right enclosure for your laptop and mount the SSD.Ĭonnect the enclosure to another Mac computer via provided USB 3.0 cable. Do not try to install a third party SSD into this enclosure or you will damage the drive. IMPORTANT NOTE: The OWC Envoy enclosure has been specifically designed for use ONLY with the factory SSD found installed in Apple MacBook Air. The SSD removed from a 2010/2011 model will not fit into 2012 or 2013-Current year enclosure and vice versa. ![]() SSDs installed in MacBook Air (2010/2011), MacBook Air (2012) and MacBook Air (2013/2014/2015/2017) models are different, even though they look similar. Remove one Torx T5 screw securing the SSD.įor data access and recovery you will need a special external enclosure for Apple SSD drives. Remove 10 pentalobe screws from the bottom cover. Method 1: Recover Deleted Files from Dead Hard Drive with Data Recovery Software So, how to get files off a dead MacBook Let’s start with the quickest and most effective method, which is using a specialized data recovery tool. MacBook Air 11-inch or 13-inch (2010/2011, 2012, 2013- Current models)įor the following procedure you will need Torx T5 screwdriver and 5-Point Torx Plus (Pentalobe compatible) screwdriver. ![]() Then click Scan button to start looking up all lost. If everything is connected properly and the hard drive not failing, it should be detected by the Mac. Launch 4DDiG-Mac after installation and select a location like your hard drive to start Mac data recovery. To test your external hard drive on a Mac, you can use the built-in Disk Utility tool to check for errors and the overall health of the drive. In order to connect the hard drive adapter to another Mac computer you will need a SATA to USB cable.Ĭonnect the cable to the hard drive adapter and plug it into another working Mac computer. Click the Make Bootable option next to the destination drive. Select the Recovery partition of your Mac (it should be called Recovery) and click Use as Source. The hard drive is almost ready for data recovery. Open Disk Drill, click the Create boot drive option in the top menu, select Boot drive for data recovery.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |